Setting up a Wall-Mount Bathroom Sink

The content of the article:

Recent house tendencies are leaning toward clean, uncluttered and modernistic decoration designs and a wall-mount bathroom kitchen sink could be a great addition. Any upsurge in space is normally a bonus, specifically in the toilet. This content will describe the techniques required for setting up a wall-mount bathroom kitchen sink combined with the list of equipment and components.

Step one 1 – Locating the Area for the Kitchen sink

Wall structure support bathroom sinks are often set up at a elevation of 30 in. from the ground. Take this dimension at the positioning you intend to connect the kitchen sink. With regards to the type of kitchen sink, you might have to eliminate a portion of drywall to gain access to the solid wood studs of the toilet wall structure. Use an even to tag a straight range for the drywall where you need to take it off.

Step two 2 – Providing Support for the Kitchen sink

Utilize the drywall noticed to lower through the drywall to gain access to the solid wood studs. Slice the 2 by 4 lumber to size to match between your studs. This provides obstructing and support for the wall structure mount bathroom kitchen sink. Toenail the obstructing pieces towards the studs using the galvanized screws.

Step three 3 – Closing the Wall structure

Slice the drywall to size and screw it into place using the drywall screws. Utilize the drywall tape and joint substance to full the drywall restoration. Sand and color the alternative drywall to complement all of those other bathroom and invite the color to dried out before shifting to another stage.

Read:  Where you can Place a Bathroom Heater Fan

Step 4 – Attaching the Mounting Bracket

Adhere to the manufacturer’s guidelines to support the wall structure mount bathroom kitchen sink. Some sinks will demand the usage of a mounting bracket. Gauge the kitchen sink installation height once again and attract a tag using the particular level. Hold the installation bracket against the wall structure at the correct elevation and drill a pilot opening into the wall structure studs.

Install the lag bolts through the wall structure bracket and hammer them in to the pilot openings so far as they can proceed. Then utilize the outlet wrench to tighten up the bracket towards the wall structure.

Stage 5 – Attaching the Kitchen sink

Attach the faucets and various other kitchen sink hardware towards the wall structure mount bathroom kitchen sink before attaching the kitchen sink towards the wall structure support bracket. Attach the kitchen sink towards the bracket and protected with any mounting equipment provided by the maker and check the kitchen sink for level once more.

Stage 6 – Finishing Details

Install water source lines and P-trap assemblies and look for leaks. Operate a bead of apparent or paintable caulking throughout the kitchen sink where it attaches towards the wall structure. Allow this caulk to dried out before painting if required.

Some wall structure support bathroom sinks add a complementing cut piece or parts that connect below the kitchen sink and hide water source lines and P-trap assemblies. Support this piece below the kitchen sink also to the wall structure using even more lag screws based on the manufacturer’s guidelines.

Setting up a Wall-Mount Bathroom Sink: bathroom

Video: How to install a wall mount sink and plumb it too!

Setting up a Wall-Mount Bathroom Sink

Share with friends:

Leave a Reply

Your email address will not be published. Required fields are marked *